South Bend Tools
For Machines Mfd. Since 12/21
Model SB1102
-25-
O P E R A T I O N
14.
Follow procedure in Steps 10–11 to insert
trailing end of sandpaper into right side
spring clip.
— If sandpaper does not line up correctly
with spring clip at trailing end, unwind
sandpaper, then loosen (2)
1
⁄
4
"-20 x
1
⁄
2
" cap
screws and rotate left tension wheel as
necessary (see Figure 25); tighten cap
screws, then follow Steps 10–14 to install
sandpaper.
Tension Wheel Cap
Tension Wheel Cap
Screw (1 of 2)
Screw (1 of 2)
Figure 25. Location of tension wheel cap screw.
Figure 25. Location of tension wheel cap screw.
15.
Remove tension tool from pulley.
16.
Repeat Steps 3–15 for second drum.
Cleaning Sandpaper
When sandpaper becomes clogged with gum and
sawdust, it loses its effectiveness and begins
to create more heat and will eventually fail.
Regularly cleaning your sandpaper will help keep
your machine running efficiently and reduce the
amount of build up.
Figure
Figure 26. Example of using D3003 PRO-STIK®
. Example of using D3003 PRO-STIK®
cleaning pad to clean sandpaper.
cleaning pad to clean sandpaper.
To clean sandpaper:
cleaning sandpaper
1.
Set table to thickness of cleaning pad.
2.
Run pad through sander two or three times
in different locations across the width of
drums, as shown in
Figure 26. DO NOT
take too deep of a cut—the sandpaper should
barely touch cleaning pad!
Refer to Accessories on Page 26 for cleaning
pad part number and ordering information.
