-16-
For Machines Mfd. Since 12/21
South Bend Tools
Model SB1102
P R E P A R A T I O N
Test Run
1.
Clear all setup tools away from machine.
2.
Press Emergency Stop button (B) in.
3.
Turn Conveyor Speed Control dial (C) to "0".
4.
Connect machine to power source. Digital
readout (A) should illuminate.
— If digital readout does not illuminate,
check power source.
After all preparation steps have been completed,
the machine and its safety features must be
tested to ensure correct operation. If you discover
a problem with the operation of the machine or
its safety components, do not operate it further
until you have resolved the problem.
Note:
Refer to Troubleshooting on Page 41 for
solutions to common problems that occur with
all drum sanders. If you need additional help,
contact our Tech Support at (360) 734-1540.
The test run consists of verifying the following:
• Motors power up and run correctly.
• Emergency Stop button works correctly.
To test run machine:
Serious injury or death can result from using
this machine BEFORE understanding its
controls and related safety information. DO
NOT operate, or allow others to operate,
machine until the information is understood.
Figure 12. Control panel.
B
B
D
D
C
C
A
A
F
F
E
E
G
G
DO NOT start machine until all preceding
setup instructions have been performed.
Operating an improperly set up machine may
result in malfunction or unexpected results
that can lead to serious injury, death, or
machine/property damage.
Refer to Figure 12 during Test Run. Each
control has an alphabetical callout for
identification.
