For Machines Mfg. Since 7/09
Model SB1016/SB1036
-45-
O P E R A T I O N
9.
Use calipers to measure both ends of the
workpiece.
— If the machined workpiece is
thicker
at the tailstock end, move the tailstock
toward
the operator
1
⁄
2
the distance of the
amount of taper (see
Figure 70
).
10.
Repeat
Steps 7–9
until the desired accuracy
is achieved.
Move the tailstock toward
the operator half the
distance of the taper.
Looking down from above.
Figure 70. Adjust tailstock toward the operator.
— If the machined workpiece is
thinner
at
the tailstock end, move the tailstock
away
from the operator
1
⁄
2
the distance of the
amount of taper (see
Figure 71
).
Move tailstock away from
the operator half the
distance of the taper.
Looking down from above.
Figure 71. Adjust tailstock away from the operator.
