PREPARATION
-8-
For Machines Mfg. Since 7/09
EVS Toolroom Lathes
P R E P A R A T I O N
Preparation Overview
Things You'll Need
To complete the preparation process, you will
need the following items:
For Lifting and Moving
s
!&ORKLIFTOR/THER0OWER,IFTING$EVICE
(rated for at least 5000 lbs).
s
,IFTING3TRAP
or Chain with Hook
(rated for at least 5000 lbs.)
s
Helper for moving machine.
s
Two 12" 2x6's
s
0RECISION,EVEL
For Power Connection
s
!QUALIFIEDELECTRICIANTOENSUREASAFEAND
code-compliant connection to the power
source. (Refer to
Page 15
for details.)
For Assembly
s
Cotton Rags
s
Mineral Spirits
s
Quality Metal Protectant Oil
s
3AFETY'LASSES
s
Wrench or Socket 21mm
s
Wrench or Socket 19mm
s
&LOOR-OUNTING(ARDWARE
as Needed
s
Standard Screwdriver #2
Unpacking
This item was carefully packaged to prevent
damage during transport. If you discover any
damage, please immediately call Customer
Service at (360) 734-1540 for advice. You may
need to file a freight claim, so save the containers
and all packing materials for possible inspection
by the carrier or its agent.
The purpose of the preparation section is to help
you prepare your machine for operation. The
list below outlines the basic process to follow to
prepare the lathe for operation. Specific steps for
each of these points will be covered in detail later
in this section.
The typical preparation process is as follows:
1.
Unpack the lathe and inventory the contents
of the box/crate.
2.
Clean the lathe and its components.
3.
Identify an acceptable location for the lathe
and move it to that location.
4.
Level the lathe and either bolt it to the floor
or place it on mounts.
5.
Assemble the loose components and make
any necessary adjustments or inspections to
ensure the lathe is ready for operation.
6.
Connect the lathe to the power source.
7.
Test run the lathe to make sure it functions
properly and is ready for operation.
