-22-
For Machines Mfd. Since 9/20
South Bend Tools
Model SB1092 & SB1094
P R E P A R A T I O N
Test Run
After all preparation steps have been completed,
the machine and its safety features must be
tested to ensure correct operation. If you discover
a problem with the operation of the machine or
its safety components, do not operate it further
until you have resolved the problem.
Note:
Refer to Troubleshooting on Page 40
for solutions to common problems. If you need
additional help, contact our Tech Support at
(360) 734-1540.
The test run consists of verifying the following:
• Motor powers up and runs correctly.
• Stop button works correctly.
• Remote control works correctly.
DO NOT start machine until all preceding
setup instructions have been performed.
Operating an improperly set up machine may
result in malfunction or unexpected results
that can lead to serious injury, death, or
machine/property damage.
Serious injury or death can result from using
this machine BEFORE understanding its
controls and related safety information. DO
NOT operate, or allow others to operate,
machine until the information is understood.
To test run your machine:
1.
Clear all setup tools away from machine.
2.
Lock all swivel casters on base.
3.
Connect machine to dust-collection system or
place covers over inlet adapter ports.
IMPORTANT:
DO NOT operate the dust
collector without first connecting it to a dust-
collection system or covering an inlet adapter
port. Otherwise, the lack of airflow resistance
will cause the motor to operate at full
amperage load, which could trip your circuit
breaker or blow a fuse.
4.
Press STOP button in.
5.
Connect machine to power.
6.
Standing away from intake port, press green
button to turn machine ON. Verify motor
starts up and runs smoothly without any
problems or unusual noises.
7.
Press STOP button to turn machine OFF.
8.
To test remote control operation, press
remote ON button to turn motor ON. The
motor should run smoothly with little or no
vibration or rubbing noises.
9.
Press remote OFF button to turn motor
OFF.
— If the machine does start or stop, press
Stop button to turn machine OFF.
Refer to Pairing Remote Control to
Receiver on Page 39 and ensure remote
control is paired.
