South Bend Tools
For Machines Mfd. Since 12/20
Model SB1117
-21-
P R E P A R A T I O N
—
If belt does not track centered on drums,
you must adjust belt tracking before
proceeding to next step so belt is not
damaged. Refer to Checking/Adjusting
Belt Tracking on Page 26 and follow
Steps 3
–
8 before continuing.
7
. Close and secure end table dust hood and
back stop door.
8
. Start machine and allow it to run while
ensuring belt tracks properly.
The motor should run smoothly and without
unusual problems or noises and belt MUST
rotate in same direction as arrows of belt
rotation on machine.
— If motor runs smoothly and belt rotates in
correct direction, proceed to Step 9.
— If motor does not run smoothly, or belt
does not rotate in correct direction,
turn machine OFF and disconnect
power. Contact Technical Service before
proceeding.
9.
Press E-Stop button to turn machine OFF.
10.
WITHOUT resetting E-Stop button, try
to start machine by pressing ON button.
Machine should not start.
— If machine does not start, safety feature
of E-Stop button is working correctly.
Congratulations! Test run is complete.
— If machine does start, immediately turn it
OFF and disconnect power. Safety feature
of E-Stop button is NOT working properly
and must be replaced before further using
machine. Contact Technical Support.
3
. Press E-Stop button in (see Figure 26).
4.
Connect machine to power source.
5
. Twist E-Stop button clockwise until it
springs out (see Figure 27). This resets the
switch so machine can start.
Figure
Figure 27. Resetting the switch.
. Resetting the switch.
6
. Use ON and E-Stop buttons (see Figure
26) to start and immediately stop machine,
while watching how belt tracks on drums.
Belt "tracking" refers to belt positioning on
drums when belt rotates. When tracking
properly, belt remains centered on drums as
they rotate.
—
If belt tracks centered on drums, proceed
to Step 7.
Figure
Figure 26. Power control components.
. Power control components.
E-Stop
E-Stop
Button
Button
ON Button
ON Button
