MAINTENANCE
-66-
For Machines Mfg. Since 3/11
Turn-Nado
®
Gearhead Lathes
M A I N T E N A N C E
Maintenance Schedule
Cleaning & Protecting
Regular cleaning is one of the most important
steps in taking care of this lathe. We recommend
that the cleaning routine be planned into the
workflow schedule, so that adequate time is set
aside to do the job right.
Typically, the easiest way to clean swarf from
the bed ways and chip drawer is to use a wet/dry
shop vacuum that is dedicated for this purpose.
The small chips left over after vacuuming can be
wiped up with a slightly oiled rag. Avoid using
compressed air to blow off chips, as it may drive
them deeper into moving surfaces and could
cause sharp chips to fly into your face or hands.
Besides the ways, all other unpainted and
machined surfaces should be wiped down daily
to keep them rust-free and in top condition. This
includes any surface that is vulnerable to rust
if left unprotected (especially any parts that are
exposed to water-soluble coolant). Typically,
a thin film of oil is all that is necessary for
protection.
For optimum performance from this machine,
this maintenance schedule must be strictly
followed. We strongly recommend all operators
make a habit of following the daily maintenance
procedures. Use the chart provided on Page 67
to ensure this is done.
Ongoing
The condition of machine components should be
carefully observed at all times to minimize the
risk of injury or machine damage. If any of the
conditions below are observed, stop the lathe
immediately, disconnect power, and correct the
condition before resuming operations:
• Loose mounting bolts or fasteners.
• Worn, frayed, cracked, or damaged wires.
• Guards removed.
• STOP button not working correctly or not
requiring you to reset it before starting the
machine again.
• A reduction in braking speed or efficiency.
• Oil level not visible in the sight glasses.
• Coolant not flowing out.
•
Damaged or malfunctioning components.
Daily, Before Operations
• Check/add headstock oil (
Page 68).
• Check/add gearbox oil (
Page 69).
• Check/add apron oil (
Page 70).
• Check/add coolant (
Page 74).
• Lubricate the ways (
Page 71).
• Add oil to the ball oilers (
Page 72).
• Clean/lubricate the leadscrew (
Page 72).
• Disengage the feed control lever on the apron
(to prevent crashes upon startup).
• Ensure carriage lock bolt is loose.
Daily, After Operations
• Depress STOP button and shut OFF
the
master power switch (to prevent accidental
startup).
• Vacuum/clean all chips and swarf from bed,
slides, and chip drawer.
• Wipe down all unpainted or machined
surfaces with an oiled rag.
Monthly
• Drain and clean the coolant tank, then add
new fluid (Page 74).
Annually
• Change the headstock oil (
Page 68).
• Change the apron oil (
Page 70).
• Change the gearbox oil (
Page 69).
• Lubricate end gears (
Page 73).
• Check/level bedway (
Page 28).
Always disconnect power
to the machine before
performing maintenance.
Failure to do this may
result in electrocution or
accidental startup injury.
OFF
Summary of Contents for TURN-NADO SB10146PF
Page 138: ......
