25
26
REMOVING, INSTALLING AND CLEANING FILTERS
These are the steps needed to successfully replace your filters. You
should clean your filters every four months.
1) Turn off all power to your spa and remove the filter lid by lifting it out
towards you.
2) Dispose of the used filter.
3) Set the new filter inside and place the filter cap on top.
4) You then rinse the filter with a garden hose and soak the filter in a
mixture of one pint of filter cleaner with 2.5 gallons of water for at least
12 hours. The filter must be completely submerged.
WARNING: Power to your spa must be turned off prior to remov-
ing your filters. The suction at the filter is extremely strong and
can cause injury if there is no filter. NEVER run your spa without
the filters properly installed. Injury to person and damage to the
equipment can occur. Any damage to equipment due to this cir-
cumstance will not be covered under warranty.
MAINTAINING YOUR SPA
WINTERIZING YOUR SPA
It is not recommended that you drain your spa completely during freez-
ing conditions. We recommend that you leave your spa full of water with
the power on to keep the tub from freezing. If you decide to drain your
spa during freezing conditions, contact your dealer for help. Contact
your South Seas dealer before refilling a drained spa in freezing tem-
perature.
WARNING: Damage to your spa caused by freezing is NOT
covered under warranty. Please contact your local South Seas
dealer to assist you in winterizing your spa.
REPLACING THE LIGHT BULB
1) Turn off the power at the main electrical service panel.
2) Remove front access panel.
3) Locate and remove the reflector by turning it counterclockwise until-
free from the surface-top view
4) Remove the bulb from the holder.
5) Replace with new bulb. Your spa dealer has these bulbs in stock.
6) Replace the reflector by screwing it clockwise back onto the light fit-
ting.
7) Replace the front panel.
8) Turn power on at the main electrical service panel.
