SERVICE INFORMATION
SECTION
6:
MODELS: GC-2 & GC-3
COMPARTMENT DOORS
Door Hasp does not engage Door Catch property
Check if door appears loose at hinges since worn out Bronze Bushings will cause misalignment of door
and bushings must be replaced. Force out Tension Pins in Hinges with pin punch. (Refer to Parts List
Section 7 - Compartment Door Assembly). Eject Hinge Pins and remove door. Force out worn Bronze
Bushings and replace with care since this is a snug fit.
However, if door is rigid at hinges, then Door Hasp may require adjustment. Remove Cooker
Enclosure Panel. Remove Hasp Pin and either add or delete washer under Hasp for proper height.
Handwheel is binding or difficult to turn
Foreign matter or lack of lubricant on dry Thrust Screw may cause threads to bind. Refer to Section 4,
Periodic Maintenance.
If Thrust Screw is bent or threads are badly worn, remove Thrust Screw and replace. Refer to Steamer
Compartment Door Assembly, Section 7, Page 23.
Door Gasket is leaking
Gasket Retainer Cap Screws may be loose and must be tightened to prevent steam leakage.
Gasket may be nicked, cut or at end of useful life and must be replaced.
Door may hang loosely and Gasket edges do not align with compartment surface properly. Correct
as previously noted.
The Door Gasket and Aluminum Plate assembly may be hanging improperly within door on supporting
Alignment Screws. Remove Gasket Plate Assembly and adjust Alignment Screws slightly.
As previously noted, Handwheel may be difficult to turn and excessive friction prevents exerting
pressure required for sealing.
16
Summary of Contents for CQ-325S
