C
OUNTER
G
RIDDLE
I
NSTALLATION
O
PERATOR
’
S
M
ANUAL
1182629
REV
2
P
AGE
7
IN
S
TA
LLA
TI
ON
I
NSTALLATION
NOTICE
Installation must comply with
National Fuel Gas Code, ANSI Z223.1
,
Natural Gas Installation Code,
CAN/CGA-B149.1
, or the
Propane Installation Code, CAN/CGA-B149.2
, as applicable.
These installation procedures must be followed by qualified personnel or warranty will be void.
Local codes regarding installation vary greatly from one area to another. The National Fire Protection
Association, Inc. states in its NFPA 96 latest edition that local codes are the “authority having
jurisdiction” when it comes to installation requirements for equipment. Therefore, installations should
comply with all local codes.
Step 1: Unpack
IMMEDIATELY INSPECT FOR SHIPPING DAMAGE
All containers should be examined for damage before and during unloading. The freight carrier has
assumed responsibility for its safe transit and delivery. If damaged equipment is received, either
apparent or concealed, a claim must be made with the delivering carrier.
Apparent damage or loss must be noted on the freight bill at the time of delivery. The freight bill must
then be signed by the carrier representative (Driver). If the bill is not signed, the carrier may refuse
the claim. The carrier can supply the necessary forms.
A request for inspection must be made to the carrier within 15 days if there is concealed damage or
loss that is not apparent until after the equipment is uncrated. The carrier should arrange an
inspection. Be certain to hold all contents plus all packing material.
1. Uncrate carefully. Report any hidden damage to the freight carrier IMMEDIATELY.
2. Do not remove any tags or labels until griddle is installed and working properly.
Step 2: Attach Countertop Legs, Mount on Counter, or Mount on Stand
The counter griddle can be mounted in several ways:
To mount it on short, countertop legs, go to Step 2a on page 8.
To mount it directly on a countertop, go to Step 2b on page 9.
To mount it on an insulated base on a countertop, go to Step 2c on page 10.
To mount it on a stand that rests on the floor, go either to Step 2d on page 11 (for 24", 36", and 48"
models) or to Step 2e on page 13 (for a 60" model).
