background image

Warranty 

(Continued)

• Save all instructions 

Defects Warranty Coverage: 

(a) The warranty period begins on the date the engine is purchased.

(b) General Evaporative Emissions Warranty Coverage. The engine must be warranted to the ultimate purchaser and 

any subsequent owner that the evaporative emission control system when installed was:
  (1) Designed, built, and equipped so as to conform with all applicable regulations; and
  (2) Free from defects in materials and workmanship that causes the failure of a warranted part for a period of two years.

(c) The warranty on evaporative emissions-related parts will be interpreted as follows:
  (1) Any warranted part that is not scheduled for replacement as required maintenance in the written instructions must  

  be warranted for the warranty period defined in subsection (b) (2).

  If any such part fails during the period of warranty coverage, it must be repaired or replaced by 

METL

 issuing  

  the warranty. Any such part repaired or replaced under the warranty must be warranted for a time not less than the  

  remaining warranty period.

   

  (2) Any warranted part that is scheduled only for regular inspection in the written instructions must be warranted  

  for the warranty period defined in subsection (b) (2). A statement in such written instructions to the effect of “repair  

  or replace as necessary” will not reduce the period of warranty coverage. Any such part repaired or replaced under  

  warranty must be warranted for a time not less than the remaining warranty period.
  (3) Any warranted part that is scheduled for replacement as required maintenance in the written instructions must be  

  warranted for the period of time prior to the first scheduled replacement point for that part. If the part fails prior to the  

  first scheduled replacement, the part must be repaired or replaced by 

METL

 Any such part repaired or replaced under 

  warranty must be warranted for a time not less than the remainder of the period prior to the first scheduled  

  replacement point for the part.
  (4) Repair or replacement of any warranted part under the warranty provisions of this article must be performed at no  

  charge to the owner at a warranty station.
  (5) Notwithstanding the provisions of subsection (4) above, warranty services or repairs must be provided at  

  distribution centers that are franchised to service the subject engines or equipment.
  (6) The owner must not be charged for diagnostic labor that leads to the determination that a warranted part is in fact  

  defective, provided that such diagnostic work is performed at a warranty station.
  (7) Throughout the evaporative emission control system’s warranty period set out in subsection (b) (2), 

METL

 issuing  

  the warranty must maintain a supply of warranted parts sufficient to meet the expected demand for such parts.
  (8) Manufacturer approved replacement parts must be used in the performance of any warranty maintenance or  

  repairs and must be provided without charge to the owner. Such use will not reduce the warranty obligations of the  

  manufacturer issuing the warranty.
  (9) The use of any add-on or modified parts will be grounds for disallowing a warranty claim made in accordance with  

  this article. The manufacturer issuing the warranty will not be liable under this Article to warrant failures of warranted  

  parts caused by the use of an add-on or modified part.
  (10) 

METL

 issuing the warranty shall provide any documents that describe the warranty procedures or policies within  

  five working days of request by the Executive Officer.

(1) Fuel Tank.

Evaporative Emission Warranty Parts List:

Questions? Call Toll Free at 1-800-737-2112 

16 

Copyright © 2009 MAT Engine Technologies, LLC

Summary of Contents for S-CV-43


















Reviews: