Questions? Call Toll Free at 1-800-737-2112
Copyright © 2011 MAT Engine Technologies, LLC
Assembly
(Continued)
• Save all instructions
If you need assistance or have any questions,
CALL TOLL FREE: 1-800-737-2112.
11
TO ASSEMBLE THE WHEELS (See Figure 8)
IMPORTANT:
Before assembling the wheels, consider your
lawn and decide which available cutting height is best for
your lawn. For best results, never cut off more than one-
third of the total length of the grass.
NOTE:
Use 3/4 and 9/16 in. wrenches, sockets or adjustable
wrenches to complete the following steps.
Each corner of the mower deck has a group of 3 vertical
holes representing the 3 possible cutting height settings.
The cutting height is fixed and adjusted with the choice of
hole the wheels are assembled. Make sure to assemble
the wheels in the same choice of hole for each corner of
the deck.
Item numbers in assembly instructions and figure correspond to
parts list on page 7.
1. Secure each wheel to the deck by inserting the
axle bolt (item 1) into and through the wheel (item16),
washer (item 9), and hole in the deck. Secure with
flange nut (item 11).
a. To adjust the cutting height, disassemble each wheel
and re-assemble to your new choice of hole location /
cutting height.
NOTE:
Make sure all four (4) wheels are assembled in the
same wheel height position.
Figure 8
Hole for 2.25”
cutting height
Hole for 2.88”
cutting height
Hole for 3.5”
cutting height
