Questions? Call Toll Free at 1-800-737-2112
Copyright © 2013 MAT Engine Technologies, LLC
ENG - 8
Assembly
• Save all instructions
If you need assistance or find any parts missing, CALL
TOLL FREE: 1-800-737-2112.
NOTE
: All references to right or left side of the mower are from the operator’s position behind the unit.
IMPORTANT
: The assembly instructions were written for persons with some mechanical ability and experience. All steps
are not included in these instructions. Persons with some mechanical ability are familiar with tightening fasteners so these
steps are not included. Do not attempt to assemble beyond your ability.
This mower was assembled at the factory with the exception of a few parts left unassembled for shipping purposes. To
ensure safe and proper operation of this mower, all parts and hardware assembled must be tightened securely. Always
use the correct tools to ensure proper tightness. All parts such as nuts, washers, bolts, etc., necessary to complete the
assembly have been\placed in the parts bag.
WARNING
Do not operate the mower if it is damaged or not securely and fully assembled.
IMPORTANT:
DO NOT ADD ENGINE OIL BEFORE COMPLETING THE ASSEMBLY STEPS BELOW. DURING AS-
SEMBLY THE ENGINE MAY BE TIPPED FOR EXTENDED TIMES. OIL CAN DRAIN INTO THE UPPER PART OF THE
ENGINE CAUSING DIFFICULTY IN STARTING ENGINE.
PARTS INCLUDED WITH THE PACKED MOWER
NOTE:
Hardware not shown full size.
Item
No.
Description
Qty
1 (J)
Screw 5/16-18 round head square neck
2
2 (K)
Locknut 5/16-18 hex nylon insert flange
2
3 (H)
Starter Rope Guide
1
4 (N)
Locknut 1/4-20 hex nylon insert flange
1
6
Oil, 20 fl. oz. (592 ml)
1
not
shown
Manual, Owners
1
Manual, Engine
1
Wheel Height Instruction Sheet
1
TO REMOVE MOWER FROM CARTON (FIG. 1)
1. Remove loose parts included with mower.
2. Cut down two end corners of carton and lay end panel
down flat.
3. Remove all packing materials except padding between
upper and lower handle (B) and padding holding blade
control lever (A) to upper handle.
4. Roll mower out of carton and check carton thoroughly for
additional loose parts.
6
4
1
2
3
Fig. 1
5
