10
Skystream hybrid 6
TM
Installation Manual, Rev A
tapered ring and gear inStallatiOn
1. disassemble the two shell assemblies by removing the 10 screws/
washers that are located on both sides of the assemblies. Save hard-
ware for later use. See Figure 1.
2. Install four of the eight tapered rings to the bottom-side of the upper
tower ring. Use four ¼”-20 x 7/8”l bolts, lock washers, and flat wash-
ers (from the tapered ring/gear mounting hardware) for each tapered
ring. See Figure 2. After tightening, the four tapered rings should fit
flush to each other without gaps.
3. Install the remaining four tapered rings to the top-side of the lower
tower ring. Use ¼”-20 x 7/8”l bolts, lock washers, and flat wash-
ers on the two ends of each Tapered Ring as shown in Figure 3. The
middle two hole locations should be left vacant for now.
4. Install the two sun tracking gears to the bottom-side of the lower
ring. Ensure the spacers on the gears are facing up. Use four ¼-20
x 1-3/4”l bolts, lock washers, and flat washers for each gear. See
Figure 3.
Figure 1
Figure 2
Figure 3
Summary of Contents for Skystream Hybrid 6
Page 2: ......
Page 20: ...20 Skystream Hybrid 6tm Installation Manual Rev A...
