12
Skystream hybrid 6
TM
Installation Manual, Rev A
11. Adjust the top eight (8) tapered rollers by loosening the jamb nuts,
and adjusting the threaded axles. Adjust the tapered rollers such that
the threaded axles protrude the same distance from the frame. See
Figure 6. There should be minimal play between the shell assembly
and the tower after tightening. If too much play still exists, re-adjust
all rollers the same amount. Tighten the jamb nuts once all rollers are
adjusted. Confirm the shell assemblies roll freely around the tower.
12. Install the hard stop bracket using the parts in the hard stop hardware
package. Attach the bracket to the bottom of the frame as shown in
Figure 7. Use two ¼”-20 x ¾” bolts, flat washers and lock washers.
NOTE: The 3/8”-16 x 1-1/4” stop-bolt can be used during
assembly or maintenance to lock the tracker in place.
Figure 6
Figure 7
Summary of Contents for Skystream Hybrid 6
Page 2: ......
Page 20: ...20 Skystream Hybrid 6tm Installation Manual Rev A...
