②
Press [Parameter setting] key and select [+] or [-] key to correct the
problem:
Press[Mode changeover] to EXIT; Press [Parameter setting]to make long blade
work( press once for each cutting);Press[+] to forward paper ;Press [-] to
reverse paper(press once for each step)
③
Press the [Mode changeover] key to return to the standby state.
④
Use the frontal end datum detection; Or make the printed mark
■
conform
the set requirement.
3-5 Cut Mark sensor fail
Cause: In the mark
■
detection mode, non-white paper is used.
①
When the LCD shows: Mark sensor failed,
Press[Mode changeover], the LCD will show:
②
Press [Parameter setting] key and select [+] or [-] key to settle the
problem :
Press[Mode changeover] to EXIT; Press [Parameter setting]to make long blade
work( press once for each cutting);Press[+] to forward paper ;Press [-] to
reverse paper(press once for each step)
③
Press the [Mode changeover] key to return to the standby state.
④
Use the frontal end datum detection; Or use white paper under the mark
■
detection mode
3-6 Paper is too narrow
①
Press[Mode changeover],the LCD will show:
②
Press [Parameter setting] key and select [+] or [-] key to settle the
problem :
<M>:EXIT <S>:
↓
<+>:
←
<
－
>:
→
<M>:EXIT <S>:
↓
<+>:
←
<
－
>:
→
40
Summary of Contents for Graphic Whizard PT320 CC
