TRAK Machine Tools
Site Preparation Guide
TRAK DPMRX7
F16467-44 Rev 062518
Page 1 of 3
Before an Authorized Field Service Technician can perform the machine’s final checkout, the following requirements must be met:
The machine must be in position and placed on its rest pads
To move the machine while on the pallet, a 15000 lb. forklift with a 24” load
center & 6’ fork extensions is required. Depending on the load center or rating
of the forklift, a larger fork lift may be required. The center of gravity (CG) of
the machine while on the pallet is 42” from the edge of the pallet. Please see
the manual for more information about lifting the machine.
The machine must be leveled (refer to installation and service manual).
The machine must be wired (refer to the installation and service manual).
The machine must have air hooked up if power drawbar is installed (see the
installation and service manual).
The machine must be cleaned. Remove all grease from the way surfaces.
Space & Weight
•
Floor area = 168.5” x 119”
•
Height = 87.875”
•
Footprint = 42.52 x 63”
•
Net (approx.) Weight = 7480 lbs.
•
Shipping (approx.) Weight = 7700 lbs.
•
Pallet Size = 91 x 84”
•
Allow clearance at the rear of the mill to open
and work on the electrical box.
•
A solid and level foundation to maintain
approximately 7480 lbs plus the weight of the
workpiece (maximum total 9680 lbs) is
required. Six leveling screws are provided.
Electrical
•
Machine is only available in the 208 VAC
configuration (200 to 240V is acceptable). A
separate 208V, 42 amps, 60 Hz, 3 phase
circuit is required. For shops with 440 VAC, a
step-down transformer to 208 VAC must be
used. The transformer must be sized to carry
a load of 42 amps minimum.
•
Machine tool must be earth grounded.
Air (for optional Power Drawbar)
•
¼” NPT connection
•
Air pressure not to exceed 100 psi
•
17.5 SCFM or 2.5 CFM at 90 psi
DPMRX7 Machine Footprints
A
Overall Width
168.5”
B
Overall Length
119”
C
Bed width
42.52”
D
Bed width between leveling screws
39.76”
D1
Bed with between leveling screws
26.57”
E
Distance between leveling screws
26.57”
F
Bed length
63”
