Southwestern Industries, Inc
.
Site Preparation Guide
TRAK DPMSX5P
Before an Authorized Field Service Technician can perform the machine’s final checkout, the following requirements must be met:
The machine must be in position and placed on its rest pads
To offload the machine, a 10000 lb. forklift with 6’ extension is required.
The machine must be leveled (refer to installation and service manual).
The machine must be wired (refer to the installation and service manual).
The machine must have air hooked up if power drawbar is installed (see the
installation and service manual).
The machine must be cleaned. Remove all grease from the way surfaces.
Space & Weight
Floor area = 136” x 71”
Height = 98”
Footprint = 24” x 48.4”
Net (approx) Weight = 4400 lbs.
Shipping (approx) Weight = 4700 lbs.
Pallet Size = 6’ x 6’, 8” thick
Allow clearance at the rear of the mill to open and work on the electrical box.
A solid and level foundation to maintain approximately 4400 lbs. plus the
weight of the work piece (maximum total 6200 lbs) is required.
Six leveling screws are provided.
Electrical
Machine with Spindle Control Option is
only available in the 220 VAC configuration.
A separate 220V, 17.5 amp minimum, 60 Hz, 3 phase
circuit is required. For shops with 440 VAC, a step-down
transformer to 220 VAC must be used. The transformer
must be sized to carry a load of 17.5 amps minimum.
A separate 110 VAC, 10 Amps minimum, 60 Hz
circuit is required to maintain proper operation.
Machine tool must be earth grounded.
Air
(for optional Power Draw Bar)
¼” NPT connection
Air pressure not to exceed 100 psi
17.5 SCFM or 2.5 CFM at 90 psi
F16467-37 rev 051317
Page 1 of 4
DPMSX5P Machine Footprints
A
Overall width
136”
B
Overall length
81”
C
Bed width
24”
D
Bed width between leveling screws
21.7”
E
Distance between leveling screws
20.5”
F
Bed length
48.4”
Summary of Contents for TRAK DPMSX5P
Page 2: ......
