Southworth Stack-N-Go FPS3000-43NFO-21, Owner'S Manual

6

Southworth Products

FPS3000-43NFO-21/27 Manual

4.  Electrical cables and wiring harness
5.  Loose or missing parts
6.  Nameplates, precautionary and instructional markings and/or labeling
7.  Guarding system
8. 

Items specified by the manufacturer

Problem or Malfunctions

 - Any problems or malfunctions that affect the safety of operations shall 

be repaired prior to the use of the machine.

Before Operations - 

The operator shall:

1.  Read and understand the manufacturer’s operating instruction(s) and user’s safety rules or 

have them explained

2.  Understand all labels, warnings, and instructions displayed on the machine or have them 

explained.

Workplace Inspections

 - Before the machine is used and during use, the operator shall check 

the area in which the machine is to be used for possible hazards such as, but not limited to:

1. 

Bumps, floor obstructions and uneven surfaces

2.  Overhead obstructions and electrical hazards
3.  Presence of unauthorized persons
4.  Other possible unsafe conditions as noted in the operating manual.

Operator Warnings and Instructions

 -  The operator shall ensure the operation of the machine 

is in compliance with the following:

1. 

Guarding system

 - Guarding shall be installed and positioned, and access gates or 

openings shall be secured per the manufacturer’s instructions (If applicable).

2. 

Distribution of load 

- The load and its distribution on the platform shall be in accordance 

with the manufacturer’s rated capacity for that specific configuration. 

3. 

Maintaining overhead clearance

 -  The operator shall ensure that adequate clearance is 

maintained from overhead obstructions and energized electrical conductors and parts.

4. 

Point of Operation

 - The operator shall not place any part of their body under the platform.

5. 

Precaution for moving equipment

 - When other moving equipment or vehicles are 

present, special precautions shall be taken to comply with the safety standards established 

for the workplace. 

6. 

Reporting problems or malfunctions

 - The operator shall immediately report to a 

supervisor any problem(s) or malfunction(s) that become evident during operation. The 

operator shall ensure all problems and malfunctions that affect the safety of operations are 

repaired prior to continued use.

7. 

Capacity limitation 

- Rated capacity shall not be exceeded when loads are transferred to 

the load enclosure.

8. 

Work area 

- The operator shall ensure the area surrounding the machine is clear of 

personnel and equipment before lowering the load enclosure.

9. 

Securing the machine 

- The operator shall comply with the means and procedures 

provided to protect against use by an unauthorized person(s).