Hardware Setup
15
IDE1/IDE2 – On-board Primary/Secondary IDE HDD
Connectors
Attach cables of hard disk drives to these connectors.
CN5 – IR Connector
Attach a 5-pin infrared device cable to this connector for enabling the
infrared transfer function. This mainboard meets the specification of
ASKIAR and HPSIR.
CN2 – Keyboard Connector
A 5-pin female DIN keyboard connector is located at the rear of the
board. Plug the keyboard jack into this connector.
J17 – Keylock & Power LED Connector
J17 is a connector for a lock that may be installed on the system case for
enabling or disabling the keyboard. J17 also attaches to the caseÕs Power
LED. (Pin 1, 3 for power LED and pin 4, 5 for keylock.)
CN1 – PS/2 Mouse Connector
Attach PS/2 mouse cable to this connector.
PRT – Parallel Port Connector
Attach parallel port cable to this connector.
PW – Power Supply Connector
The mainboard requires a power supply with at least 200 watts and a
Òpower goodÓ signal. PW has two 6-pin male header connectors. Plug
the dual connectors from the power directly onto the board connector
while making sure the black leads are in the center.
