BIOS Setup
29
PM Control by
APM
Choose
Yes
(default) or
No
. APM stands for
Advanced Power Management. To use APM,
you must run Òpower.exeÓ under DOS v6.0 or
later version.
Video Off Method
Choose
V/H Sync+Blank
(default),
Blank
screen
, or
DPMS
for the selected PM mode.
Video Off After
Choose
Standby
(default),
Suspend
,
Doze
, or
N/A mode
.
Modem Use IRQ
Choose Modem IRQ Setting.
Doze Mode
When the set time has elapsed, the BIOS sends
a command to the system to enter doze mode
(system clock drops to 33MHz). Time is
adjustable from 1 Min to 1 Hour.
Standby Mode
The default is Disabled. Time is adjustable
from 1 Min to 1 Hour.
Suspend Mode
The default is Disabled. Only an SL-Enhanced
(or SMI) CPU can enter this mode. Time is
adjustable from 1 Min to 1 Hour. Under
Suspend mode, the CPU stops completely (no
instructions are executed.)
HDD Power Down
When the set time has elapsed, the BIOS sends
a command to the HDD to power down, which
turns off the motor. Time is adjustable from 1
to 15 minutes. The default setting is Disabled.
Some older model HDDs may not support this
advanced function.
Soft-Off by PWR-
BTTN
Choose
Instant-off
(default) or
Delay 4 Sec
.
Delay 4 Sec
turns off the system power 4
seconds after pushing the power button
VGA Active
Monitor
Choose Enabled (default) or Disabled.
Enabled Ð enables the power management
timers when a Òno activityÓ event
is detected.
