36
BIOS Setup
Hot Key Power On
If you select ÒHot KeyÓ from the item
above, you will have to choose a key
combination that will wake up the
system here. Choose from Ctrl-F1 to
Ctrl-F12.
Onboard FDC Controller
Enabled Ð Use the on-board floppy
controller (default).
Disabled Ð Turn off the on-board floppy
controller.
Onboard Serial Port 1/
Onboard Serial Port 2
Choose serial port 1 & 2Õs I/O address.
Do no set port 1 & 2 to the same value
except for Disabled. Choose Auto for
automatic setting for the I/O address and
IRQ.
COM1/3F8H
COM3/3E8H
COM2/2F8H
COM4/2E8H
(default)
UART Mode Select
Choose Normal (default), IrDA 1.0, or
ASKIR to meet the specification of your
Infra Red device.
RxD, TxD Active
Choose Hi, Hi; Hi, Lo (default); Lo, Hi;
or Lo, Lo. Ask your IR provider when
you use this function.
IR Transmission Delay
Choose Enabled or Disabled. Ask your
IR provider when you use this function.
Onboard Parallel Port
Choose the parallel port I/O address:
378H/IRQ7 (default), 3BCH/IRQ7,
278H/IRQ5, or Disabled to disable this
port.
Parallel Port Mode
Choose
ECP+EPP
(default)
, SPP
,
EPP
,
or
ECP.
The mode depends on your
external device that connects to this port.
