Hardware Setup
15
J7 – CD In Connector
Connect a 4-pin audio cable, which is provided by the CD-ROM
manufacture, from the Audio-out port of the CD-ROM drive to this
connector, and also for transferring the audio signal from the CD-ROM
to the speakers system, connect speakers system audio-in cable to
speaker out jack of this mainboard.
J4 – Creative Wave Table Card Connector
This connector is reserved for Creative wave table ISA cards (i.e.,
AWE32 Upgrade CT-1920). You should be able to plug a Creative wave
table card on ISA bus then connect the cable from the wave table card to
this connector, and then connect the audio-in cable of the speakers
system to the speaker-out jack of this maminboard.
FDC Connector
Attach floppy cable to this connector.
J11 – Game Port
Attach a 15-pin male header device, which meets the game port
specifications (i.e., joystick), to this connector.
J19 – Hardware Reset Control
Attach the Reset switch to J19. Closing the Reset switch restarts the
system.
J24 – HDD LED Connectors
Attach on-board hard disk drive LEDs to this connector. The LED lights
when an HDD is active.
IDE1/IDE2 – On-board Primary/Secondary IDE HDD
Connectors
Attach on-board hard disk drives to these connectors.
