SOYO G1681 Analog Telephone Adapter User Guide
-19-
pin:
With SIP system which requires authentication, please put the password
into this field.
r
egister port
: The local UDP port registered with server to accept incoming
handshaking messages. Default is 5060
rtp port:
RTP port is the port transferring and receiving voice packets using
UDP protocol. This is an even number between 1024 and 65535, can NOT be
the same as
register port
.
tos:
Set the TOS field of the IP header of the RTP packets. The bigger this
value, the higher priority the packet is.
outbound proxy :
Enable/disable Outbound proxy by checking/clearing this
box. If the system has an Outbound Proxy
，
please set the URI of the outbound
proxy into
sip proxy
and set the domain name of SIP proxy server into
domain/realm
. The default service port is 5060.
dtmf:
Set DTMF signal sending method by selecting
inband audio
,
rfc 2833
and
sip info
from list box.
dtmf payload:
When DTMF select
rfc 2833
.This parameter can be used
indicate RTP payload type. The value can be integer 96-101.
prack:
Enable/disable pre-ack(RFC3262) support by checking/clearing this
box.
super password:
Set the super password of the ATA.
debug:
Set the debug level of the ATA.
disable:
Disable output the debug message by selecting this item.
output:
Output the operation information to the window, such as register,
input by selecting this item.
output all:
Output all debug information and data in test window by
selecting this item.
remote debug:
Save
the debug information in SDRAM of ATA by
selecting this item.
no check:
Disable checking firmware tags when upgrading. This is not
suggested, because it will increase the risk of upgrading the wrong
firmware into the ATA.
