Hardware Setup
SY-6BE+
23
Step 13. CMOS Clearing (JP5)
After you have turned off your computer, clear the CMOS memory
by momentarily shorting pins 2-3 on jumper JP5, for a few seconds.
Then restore JP5 to the initial 1-2 jumper setting in order to recover
and retain the default settings.
After you have turned off your computer, clear the CMOS memory by
momentarily shorting pin 2-3 on jumper JP5 for at least 5 seconds. Then
permanently short pin 1-2 to retain new settings.
Jumper JP5 can be easily identified by its white colored cap.
CMOS
Clearing
Clear CMOS Data
Retain CMOS Data
(Default)
JP5
Setting
Short pin 2-3 for
at least 5 seconds
to clear the CMOS
Short pin 1-2
to retain new
settings
Note: You must unplug the ATX power cable from the ATX power
connector when performing the CMOS Clear operation.
Step 14. Power-On by Keyboard Jumper (JP10)
You can choose to enable the Power-On by Keyboard function by
shorting pin 1-2 on jumper JP10, otherwise, short pin 2-3 to disable
this function.
Power-On by
Keyboard
Enable
Disable
JP10 Setting
Short pin 1-2 to enable
the Power-On by
Keyboard function.
Short pin 2-3 and the
Power-On by Keyboard
function is disabled.
Note: When using the Power-On by Keyboard function,
please make sure the ATX power supply can take at least
720mA load on the 5V Standby lead (5VSB) to meet the
standard ATX specification.
3
2
1
3
2
1
3
2
1
3
2
1
Summary of Contents for SY-6BE+
Page 66: ...63...
