Hardware Installation
SY-7ISA
48
Step 1.
Select [STANDARD CMOS SETUP]
Set [Date/Time] and [Floppy drive type], then set [Hard Disk Type] to
“Auto”.
Step 2.
Select [Load Optimized Defaults]
Select the “Load Optimized Defaults” menu and type “Y” at the prompt to
load the BIOS optimal setup.
Step 3.
Select [Soyo Combo Feature]
Move the cursor to the
[CPU Frequency]
field to set the CPU frequency.
The following table shows all available [CPU Frequency] settings on your
SY-7ISA Motherboard . If you set this field to [Manual], you will be
required to fill in the next two consecutive fields: (1) the CPU Host/PCI
Clock, and (2) the CPU Ratio.
CPU Frequency (MHz)
500MHz (100 x 5.0)
533MHz (133 x 4.0)
Manual
550MHz (100 x 5.5)
600MHz (133 x 4.5)
400MHz (66 x 6.0)
600MHz (100 x 6.0)
666MHz (133 x 5.0)
433MHz (66 x 6.5)
650MHz (100 x 6.5)
733MHz (133 x 5.5)
466MHz ( 66 x 7.0)
700MHz(100 x 7.0)
800MHz (133 x 6.0)
500MHz( 66 x 7.5)
750MHz (100 x 7.5)
866MHz (133 x 6.5)
533MHz ( 66 x 8.0)
800MHz (100 x 8.0)
933MHz (133 x 7.0)
Select the working frequency of your Pentium
®
III, Celeron
processor among these preset
values.
Note:
Mark the checkbox that corresponds to the working frequency of your Pentium
®
III, Celeron
processor in case the CMOS configuration should be lost.
Step 4.
Select [Save & Exit Setup]
Press
<Enter>
to save the new configuration to the CMOS memory, and
continue the boot sequence.
