Hardware Setup
SY-D6IBA
23
Step 15. Power Button Enable (JP2)
Your system can be power on by either pressing a power button or
typing in a password, which can be set in the BIOS SOYO COMBO
Setup. To avoid being unable to power up the system due to of
forgetting the password, you can place a jumper cap to short JP2.
This will always enable the Power Button.
Power Button
Enable
Power Button always
enabled
Power Button
according to BIOS
setting
JP2 Setting
Short pin to
always enable
the Power
Button.
Open pin for a
Power Button
function according
to the BIOS setting.
Step 16. Power On
You have now completed the hardware installation of your
Motherboard successfully.
1. Turn the power on
2. To enter the BIOS Setup Utility, press the <DEL> key while the
system is performing the diagnostic checks,
Note:
If you fail to enter the BIOS, wait until the boot up
sequence is completed. Then push the RESET button and
press <DEL> key again at the beginning of boot-up, during
diagnostic checks.
Repeat this operation until you get the following screen.
Summary of Contents for SY-D6IBA
Page 75: ...72 ...
