Hardware Installation
SY-P4-645DX DRAGON Ultra
34
Step 1.
Select [STANDARD CMOS SETUP]
Set [Date/Time] and [Floppy drive type], then set [Hard Disk Type] to
“Auto”.
Step 2.
Select [LOAD OPTIMIZED DEFAULTS]
Select the “LOAD OPTIMIZED DEFAULTS” menu and type “Y” at the
prompt to load the BIOS optimal setup.
Step 3.
Select [SOYO COMBO FEATURE]
Select the desired
System Freq. (CPU:DRAM)
in the table. To over clock
the system, set the CPU/DRAM Frequency to manual, the CPU, DRAM,
AGP Frequency select option will be available.
To over clock your CPU’s Front Side Bus,
[CPU Frequency Select]
enables
you to over clock in 1MHz increment or you can input the desired FSB
value of the CPU.
Set the
[DRAM Frequency Select]
to “100MHz x 2”, “133MHz x 2” or
“166MHz x 2”, depending on the DRAM frequency you have in the system,
or choose a desired DRAM frequency in the table to over clock your DRAM.
If you over clock your CPU’s Front Side Bus, it over clock your DRAM
frequency as well.
[AGP Frequency Select]
to choose a desired AGP frequency in the table to
over clock your AGP. See “Default Setting Table” below for AGP default
setting info.
Note:
•
Over clocking the CPU FSB will also over clock the DRAM/AGP
frequency, unless user manually change the DRAM/AGP
frequency to desired value.
•
Over clocking the DRAM Frequency will also over clock the AGP
frequency. The CPU frequency is not affected.
•
Over clocking the AGP Frequency will not affect or over clock the
CPU or DRAM frequency
