IMPORTANT
READ THIS FIRST
●
Inspect stair for any damage prior to installation.
●
Stair is NOT to be installed while home is under construction and
used as a construction stair.
●
The correct number of treads for floor-to-ceiling height MUST be
attached. The stair may have had one of the 3 extra steps pre-
installed at the factory. To determine the correct number of treads
that should be installed for your height, refer to Table A on page 3.
Do not add or remove treads solely for changing the angle of the stair.
This will cause an unsafe condition and damage the stair.
●
Adjustment Screw on stabilizer arm MUST be set before climbing
stair. This adjustment provides structural support necessary for
use. See page 7.
Failure to follow any or all of these
guidelines can result in damage to
the stair and will void the warranty.
If you have any problems or concerns with stair,
call SP Partners LLC immediately at 877-369-6996
Page 1
July 2014
