SPSWH.com SP Blue Solo 80 installation manual Doc
SP.
SP Blue Solo 80.E.2021.REV1.0
16
|
P a g e
7.3
Freeze Protection Label
This system is NOT freeze protected and should not be installed in any location where freezing is
possible. Should freezing temperatures occur, turn off the electrical element at the breaker and drain
the system immediately. Failure to do so could cause severe damage to the system and void the
warranty. See Decommissioning instructions in the installation manual for how to drain the system.
7.4
Hot Fluid Label
DANGER! Fluid could be discharged at high temperatures or pressures, or
both. Fluids shall not be used that would change the original classification of
this system. Unauthorized alterations to this system could result in a health
hazard or hazardous conditions.
7.5
Electrical Hazard Label
DANGER! This system contains electrical connections that could be harmful if not
connected and maintained appropriately. Please ensure that all electrical connections
are installed and inspected by a training professional and that all power to the unit is
OFF prior to service and maintenance. Failure to comply could result in injury or
death.
