11
OPERATING INSTRUCTIONS
OPERATING INSTRUCTIONS
• Turn the power switch to the “ON” (|) position.
The unit will turn on for 1 - 2 seconds and shut
off. This is a normal function of the auto start
feature. Squeeze the spray gun trigger to begin
pressure washing.
• Begin pressure washing by squeezing the trigger
on the spray gun all the way into the handle.
• Release the spray gun trigger to stop the pressure
washer.
• Allow the motor to come to a complete stop
before squeezing the trigger again.
• Squeezing rapidly will cause the auto start
feature to miss an on/off cycle that may prevent
it from turning on while squeezing trigger after
rapid squeezing. Use slow deliberate trigger pulls
to avoid such symptoms.
OFF/0
ON/I
OFF/0
ON/I
•
Always test
a small area to avoid chance of
damaging the surface.
• Turn the tap on fully to ensure good water supply.
• Make sure the “ON/OFF” switch is in the “OFF”
position. The power switch has international symbols
for ‘on’ and ‘off’: On (|) Off (O).
• Unwind the power cord completely and plug it into a
240 volt outlet.
• Release safety push trigger lock up and back into
trigger. While pointing the spray gun in a safe
direction, squeeze the trigger on the spray gun until
there is a steady stream of water, letting the water
and air out of the hose. Push trigger lock back down
to lock back into place.
