SC-CF-SBD Owner’s Manual
20
Installation
Optional Wet-End Fitting
Optional
Wet-End Fitting
To install
the fitting
To install
the sensor
The optional wet-end fitting
secures your pack
temperature sensor into
position in the spa.
1) Select a location for the
temperature sensor. It
should be below water
level, accessible and as
close as possible to the
pack.
2) Drill a 1" diameter hole
in the spa wall.
3) Install the fitting as
shown. It should be
tight enough to
prevent water leaks.
Do not forget to apply
silicone.
1) Slide the temperature
sensor inside the
stopper nut of the
wet-end fitting.
2) Insert the sensor into
the fitting. Fully insert the
sensor into the wet-end
fitting until the tip of the
sensor slightly intrudes
into the spa
3) Tighten the stopper nut to ensure proper sealing.
4) Apply foam on the back of the fitting to prevent cold or
warm air from affecting the sensor reading.
1
1/2
"
1"
1
5/8
"
Apply silicone
Stopper nut
