9
8
START ASSEMBLY OF CONNECTOR PLUG
CONTINUE ASSEMBLY OF CONNECTOR PLUG
1:
DO A PULL TEST ON THE PLUG ASSEMBLY SO FAR,
ALL ASSEMBLED PARTS SHOULD FEEL FIRM AND TIGHT
2:
PUSH CONNECTOR COLLAR ALL THE WAY IN TO THE END UNTIL THERE
ARE TWO DISTINCT “CLICKS”. THE END WILL BE FREE TO ROTATE
1
2
“CLICK”
1:
CAREFULLY THREAD CONNECTOR BARREL ONTO SCREW TERMINAL
AND TIGHTEN FIRMLY BY HAND
2:
SEAT CABLE GLAND ALL THE WAY
INTO CONNECTOR
(DO A VISUAL CHECK TO MAKE SURE
A SEAL BETWEEN GLAND AND CABLE)
3:
CAREFULLY THREAD GLAND NUT
ONTO CONNECTOR BARREL AND
TIGHTEN FIRMLY BY HAND
1
2
3
BACK OF CONNECTOR
BARREL
GLAND
CABLE
TIGHT SEAL
“CLICK”
10
