5
6
9
1
Step 6: Running the camera cable
Now run the camera cable to establish
a connection with the cable of the radio
transmitter in the vehicle‘s interior /
cavity. Be sure the cables aren‘t pinched
or knotted. Now connect the plug from the
camera cable to the socket of the radio
transmitter .
The plastic ring may optionally be
sealed with conventional sealing com-
pound on both sides to prevent water from
entering.
Step 4: Mounting the camera
Guide the plug for the camera cable
through the plastic ring and into the
interior of the vehicle or the trunk lid.
Mount the camera to the camera
brackets evenly spaced from the sides
(see image 4). Mount using the two
screws and the two clamping nuts
(see image 5). Stop turning the clamping
nuts when you feel resistance and the
camera is securely connected to the
bracket. Be sure the cable outlet at the
back of the camera always points upward
to maintain the maximum swivel range.
Step 3: Mounting the camera brackets
Mount the two camera brackets and, if
appli-cable, also the number plate frame.
Be sure the distance between the two
brackets is no less than 4 cm (see
image 3). The camera may be mounted
above or below the license number. Image
3 shows installation above the license
number.
Caution!
The location of the camera
brackets may not impair the functionality
of the license number light! If it impairs the
license number light mount the camera on
the opposite side.
9
9
Image 6
Step 5: Mounting the license number
Now mount the plate (see image 6).
Image 5
Image 4
Image 3
Example: top
mounted camera
Minimum distance 4 cm
Then clip the plastic ring into the
borehole from the outside of the vehicle.
8
11
1
1
9
5
6
1
8
1
8
11
GB
21
98106_Rueckfahrkamera_Manual _27_03_12_print
Dienstag, 27. M
rz 2012 14:09:15
