Caution!
If you are unfamiliar
with the installation and the con-
nections or are unsure with one
of these steps, please consult a specialist
regarding the installation! There is a risk
of property damage or personal injuries!
Using the second cable clamp connect
the vehicle‘s 12 V
-
(negative) reversing
light cable with the black transmitter cable
as shown in images 8 - 11. Then
reconnect the negative cable to the
vehicle‘s battery.
Close the cable
clamp fuse
cover.
Using a pair of pliers
(not included) push
the protruding metal
contact into the cable
clamp . This will
connect the two
cables.
Place the red trans-
mitter cable side-
ways into the clamp
connector (see
image 9).
Place the 12 V
+
(positive) reversing
light cable sideways
into the clamp
connector (see
image 8).
Using the two cable clamps connect
the cables to the reversing light and follow
the following steps for connecting the
respective cables.
7
7
7
7
7
7
Image 11
Image 10
Image 9
Image 8
Transmitter
Earth
Black
12 V supply cable
Image 7
Camera cable
Camera
Reversing
light
Cable
clamp
Red
+ 12 V DC reversing light
Step 7: Connecting the transmitter
supply cable
Remove the cover of the reversing light.
Remove the bulb holder from the
reversing light housing. Find the vehicle
supply cables to the reversing light.
Please refer to the automaker‘s manual.
Caution!
Disconnect the negative cable
from the vehicle‘s battery before working
on the vehicle‘s electric circuit! Stored
information, codes and programming may
be lost!
Now connect the vehicle‘s 12 V
+
(positive) power supply to the reversing
light to the red transmitter cable. Then
connect the vehicle‘s 12 V
-
(negative)
earth cable for the reversing light with the
black transmitter cable (see image 7).
GB
22
98106_Rueckfahrkamera_Manual _27_03_12_print
Dienstag, 27. M
rz 2012 14:09:16