The vehicle ignition and the
monitor are switched on and
the car is in reverse but the
display remains dark. The
blue LED doesn‘t light up.
The 12 V monitor cable plug
is not plugged into the
vehicle‘s cigarette lighter or
a 12 V outlet.
Plug the 12 V monitor cable
plug into the cigarette lighter
or a 12 V vehicle outlet.
Replace the defective fuse
inside the 12 V monitor
cable plug with a new fuse
(see item 4.6).
The fuse inside the 12 V
monitor cable plug is burnt
out and must be replaced.
Replace the defective fuse
for the cigarette lighter or
the 12 V outlet inside the
vehicle‘s fuse box.
The fuse for the vehicle‘s
cigarette lighter or the 12 V
outlet is burnt out and must
be replaced.
The ignition is switched on,
the car in reverse, but the
monitor display is blank.
There is no connection
between the camera and
the monitor. The camera
cables may not be correctly
connected or have
loosened.
Check if the camera
connection cable is correctly
and securely connected to
the reversing light cable.
The image on the monitor
shows interference.
Other wireless appliances
(e.g. mobile phone) are
interfering with the signal
between monitor and
camera.
Switch off all other wireless
appliances (e.g. mobile
phone).
The wireless connection
between monitor and
camera is too weak, thus
interfering with data trans-
mission.
Position the transmitter
closer to the monitor or
adjust the position of the
monitor.
The monitor image is not
displayed clearly.
The camera lens may be
dirty.
Carefully clean the camera
lens.
Bright light is hitting the
camera lens.
The image quality will
improve once you move out
of the area of the interfering
light.
Solutions, repair
Possible causes
Error / malfunction
4.7 Troubleshooting
GB
25
98106_Rueckfahrkamera_Manual _27_03_12_print
Dienstag, 27. M
rz 2012 14:09:17
