SPA DESIGN MICRODASH LOGGER OPERATING MANUAL
DISPLAY AND MENU SYSTEM:-
To access the MicroDash logger system menu, hold down the left button while you press the right button (repeat
this when in the menu system to exit the menu system). On the display you will see
rECL
on the LCD display,
and the menu number
01
in the middle of the display. Now release the buttons. If you now press the left button
momentarily again you will see the display change to the next menu option. Also a menu group indicator will be
displayed as appropriate EG
TA
is shown for tacho related menus. Keep pressing the left button to familiarize
yourself with the menu items. A brief sequential view of options and there meaning is shown below:-
Menu system changes
PLEASE NOTE
There has been a change to the existing menu for the MicroDash Logger:-
There has been a new menu item added: -
Display shows: Menu number
Menu Group
What it does
:
Log
00
None
Sets the logging enabled or disabled.
on
Also there has been a menu item removed: -
dELE
20
LAP
This was used to delete all lap sessions.
All other menu items remain exactly the same as the original MicroDash system.
Display shows: Menu number
Menu Group
What it does
:
Log on
00
None
Sets the logging enabled or disabled.
rECL
01
None
Use this to recall your maximums stored in memory.
rPEA
02
None
Use this to reset maximums stored in memory
b on
03
None
Use this to the backlight on or off.
bri
04
None
Use this to adjust the brightness of the backlight.
tDEg
05
AN
Use this to set which temperature units to use
Unit
06
AN
Use this to set which pressure units to use.
AnLg
07
AN
This is a sub menu. Use this to setup the analog channels
for
sensors types, alarms, letter symbols etc.
oFFP
08
AN
Use this to zero the pressure sensors (offset)
SPEE
09
SP
Use this to set the speed units to display.
trig
10
SP
Use this to set the speedo sensor trigger points number.
CirC
11
SP
Use this to set the
tyre circumference for the speedo.
38
