Form 44201360
16
Oct 2019
PN
Description
Picture
44560352 Wall / Ceiling Telescopic Mounting
Bracket Kit- 15"-30" overhead
space (check clearances to
combustibles space above the
heater before ordering) includes
both the 380-560mm (15-22”) and
560-760mm (22-30”)
extension legs.
44566300 Heat Shield Kit – Reduced
clearances to combustible option
when installed. Mounting angles
are restricted to 0°, 15°, 30°, 45°
and 60°.
44560599 Column Mounting Arm Kit –
suitable for columns 200mm (8”)
and wider.
44560607 75mm (3 ") Pole Mounting Bracket
Kit
44560608 100mm
(4")
Pole
Mounting
Bracket Kit
UNPACKING THE HEATER
11.0)
The heater and ceramic glass are shipped separate but in the same box. Care must be taken
when up-packing the heater. Carefully open the top of the heater as indicated on the labels at the side of the
shipping box. An angle gauge is attached to the heater’s control side with tape and is needed for installation (see
Section 12.1).
The glass is located on top of the heater and is wrapped in cardboard cradled into the foam end pieces. Carefully
remove the top foam pieces and remove the cardboard wrapped glass. Care must be taken that during handling
the glass does not slide out of the cardboard wrap. Store the glass in a secure location for later assembly.
