Page 8
4.
Open the quick-release clamp at top end of T-tube.
5.
Insert and secure left and right handlebars by pressing the spring-
loaded buttons and inserting them into T-tube. Make certain BOTH
handlebars are properly locked into the T-bar by spring-loaded
buttons.
6.
Close quick-release clamp to lock the handlebar. If needed, adjust
the nut at the lower end of the clamp to ensure a tighter fit.
7.
To adjust the height of the handlebars: open the quick-release
clamp on the steering pole..
8.
Press the spring-load button and raise or lower the T-bar to desired
position, and make sure that the spring-load button is locked into
the hole of the tube.
9.
Re-secure the quick release clamp to lock it into place. If needed,
adjust the nut at the left end of the clamp to ensure a tighter fit.
WARNING:
Failure to properly secure the quick-release lever may
cause the T-tube to telescope up or down while riding, which may
cause you to lose control and fall.
