3.
Using a medium sized Philips screwdriver,
attach the 2.5" (60mm) long screw to the drywall
anchor (four times). For masonry wall screw in the
screw into the masonry wall anchor.
2.
Your heater unit includes mounting hardware for
either masonry or drywall installations.
Use a 7/32” (6 mm) drill bit to drill pilot holes for
the drywall or masonry anchors; however, if you
drill into a stud use a 1/8” (3 mm) and do not use
and anchor. On a drywall wall use a Phillips head
screwdriver to screw the drywall anchor into the
pilot hole, for masonry wall, push the masonry plug
into the pilot hole until it is flushes with the wall.
2.
3.
4.
Attach adhesive pads (+ sticker) to the four
matching areas on the back of the heater unit.
4.
