SpaDealers Polar AquaKing, User Manual

CLEANING AND CHANGING THE FILTER 

All screw connections must use the rubber seals provided.  Own Assembly: During assembly of wall and base fittings, silicone 
shall be used on both sides of the connections, as well as the threads. 

ATTENTION! Near the bottom of the filter holder there is an arrow, which must be pointed towards the pump. The control system 
should also be connected if it’s included. This must be done by a qualified electrician. Close the valves on the filter before filling the 
Hot Tub.  

STARTUP 
When the system is ready for testing, open the air screw (1) on top of the filter holder and the nut (2). Close it again when water 
begins to leak out. After this procedure, the system is ready for use. Do not start the system without any water running and watch 
out that both – the tap next to the filter (suction side) as well as the tap on the pressure side are open, meaning the part connected 
to the pump (not the draining valve). 

WATERLEVEL 
The preferred water level for keeping the filtration working optimally is about 5 cm 
below the skimmers upper edge. If it is beneath the skimmer, then the pump could 
start sucking air instead of water into the filter and the control system then shuts off 
the pump and heating. 

3

2

B

B

A

1