Installation
Euro Kitchen Appliances Inc. 7272 Buller Ave, Burnaby BC www.KitchenHoods.ca
OTHER:
1. Measure the distance between stove top and the bottom of range hood. A
distance of 28” to 32” is recommended*.
*
Due to different ceiling height configurations, recommended height
may not be applicable
Using references in
Height & Clearance
on Page 5 and
Measurements and Diagrams
on Page 16, center the hood beneath the cabinet and flush with the front
of the cabinet.
Draw electrical wires through cabinet access opening and center the hood beneath the cabinet.
From inside of the hood, place screws into the exact center of each knockout hole and secure to cabinet
bottom. Finish tightening all screws until secure. Be careful when using electrical screwdriver, damage
to the range hood may occur.
CAUTION: Make certain the range hood is secure before releasing!
2. For safety purpose, pre-drilled mounting holes are provided through the back of the hood. For a more secure
installation, use as many mounting holes as needed to secure from the inside of hood.
3. Use 6” round steel pipe (follow building codes in your area) to connect the exhaust on the hood to the duct-
work above. Use aluminum tape or duct tape to make all joints secure and air tight. Refer to Figure 6.
SAFETY WARNING: Risk of electrical shock. This range hood must be properly grounded. Make sure
this is done by qualified electrician in accordance with all applicable national and local electrical codes.
Before connecting wires, switch power off at service panel and lock service panel to prevent power
from being switched on accidentally.
4. This range hood is equipped with 3,4‘ of wire ending with standard 120v plug. The installer must
connect the plug to the closest receptacle. Connect the range hood to a designated standard outlet (120-
Volt, 60Hz, AC only) or cut off the plug and connect three wires (black, white and green) to house wires and
cap with wire connectors. Connect according to colors (i.e. black to black, white to white, and green to
green). Again
qualified electrician should do any modifications and electrical connection.
10