Ceiling
Height
Venting Requirements
Page 5
Height & Clearance
Under Cabinet
Range hood
36”
Counter
Top
Min:
27”
Max: 30”
Vent system must terminate to the outside
•
(roof or side wall).
DO NOT terminate the vent system in an at
-
•
tic or other enclosed area.
DO NOT use 4” (10.2 cm) laundry-type wall
•
caps.
Use metal/aluminum vent only. Rigid metal/
•
aluminum vent is recommended.
DO NOT use plastic vent.
•
Always keep the duct clean to ensure proper
•
airflow.
Calculate the following figures before instal
-
•
lation:
Distance from the floor to the ceiling.
1.
Distance between the floor to the coun-
2.
tertop/stove (recommend* 27” to 30”).
Distance between the countertop/stove
3.
to the range hood.
Height of hood and duct cover.
4.
For the most efficient & quiet operation:
A distance of 27” to 30” is recommended*
•
between stove top and the bottom of range
hood.
It is recommended that the range hood be
•
vented vertically through the roof through 8”
(20.3 cm) or bigger round metal/aluminum
vent work.
The size of the vent should be uniform.
•
Use no more than three 90° elbows.
•
Make sure there is a minimum of 24” (61
•
cm) of straight vent between the elbows if
more than one elbow is used.
DO NOT install two elbows together.
•
The length of vent system and number of
•
elbows should be kept to a minimum to pro
-
vide efficient performance.
The vent system must have a damper. If
•
roof or wall cap has a damper, DO NOT
use damper (if supplied) on top of the range
hood.
Use silver tape or duct tape to seal all joints
•
in the vent system.
Use caulking to seal exterior wall or roof
•
opening around the cap.
* Due to different ceiling height configurations, rec
-
ommended height may not be applicable.
Cabinet
Range
Hood
Height
Cabinet
Height
Countertop/Stove
Summary of Contents for PS13
Page 2: ......
Page 19: ...Page 17 Overall PS61 PS63 Overall PS65 ...
Page 21: ...Page 19 Circuit Diagram ...
