Page 9
WARNING
Severe Injury
Rotating fan can cause se-
vere injury. Stay clear of
fan when motor is running.
WARNING
Severe Injury
Hood may have very shape edges. Please wear
protective gloves if it is necessary to remove
any parts for installing, cleaning or servicing.
Advanced Preparations:
Read the entire installation guide and users manual thoroughly, understand instructions and warnings.
1.
Be familiar with the controls of the range hood by reading through
2.
Range Hood Operations
,
Page 13.
Place the range hood on a flat, stable surface. Connect the range hood to a designated standard outlet (please
3.
refer the product label for the suitable voltage of this unit) and verify no debris has entered the vent openings,
then turn on the range hood. Verify all operations of the range hood by referring to
Range Hood Operations
,
Page 13.
Place all supplied parts and required hardware on a flat, stable surface and verify the existence of all supplied
4.
parts listed on Page 4.
Carefully remove the white plastic protective coat from the chimney covers and range hood.
5.
Preparations:
NOTE: To avoid damage to your hood, prevent debris from entering the vent opening.
Determine and mark the center line on the ceiling where the range hood will be installed. Make sure there is
1.
proper clearance within the ceiling or wall for exhaust vent.
Due to the weight and size of this unit, please make sure that the support system or framework being used is
2.
stable and secure in the ceiling.
Put a thick, protective covering over counter top, cook top or range to protect from damage or dirt. Remove
3.
any hazardous objects around the area when installing.
Mark the locations of the support mounting bracket holes, vent cutout (if used) and power supply cable cutout
4.
on the ceiling. Use drill and saber saw or keyhole saw to cut openings for power supply cable and vent (see
Venting requirements
and
Electrical requirements
, Pages 5-8).
If venting to the outside install vent system (see
5.
Venting Methods
, Page 7). Use caulking to seal exterior wall
or roof openings.
Disconnect main electrical supply, prepare and run electrical wiring through ceiling. Leave approximately 12”
6.
of electrical cord hanging from the ceiling. Do not restore power until wiring is completed.
Disconnect power cord, remove the stainless steel baffle filters and set aside until the range hood is properly
7.
installed.
If the range hood comes with a glass canopy and has not already been mounted to the hood, loosen the four
8.
canopy screws and washers from the hood top, carefully place the canopy on the hood top, and loosely tighten
the four canopy screws along with washers. DO NOT put excessive pressure against the glass.
Preparation
WARNING
DO NOT INSTALL THE RANGE HOOD BEFORE TESTING IT. MECHAN-
ICAL DAMAGE MIGHT HAVE OCCURRED DURING TRANSPORTION.
Plug in the range hood to the USA/Canada 120V standard outlet (220V for Eu-
rope and other countries), test the blower and the lights before installing it.
