Installations
(refer to Page 4 for parts)
:
Measure the distance between stove top and the bottom of
range hood. A distance of 27” to 30” is recommended*.
*
Due to different ceiling height configurations, recommend
-
ed height may not be applicable.
You have
1.
two ways
(A: Vertical Venting, or B: Horizontal Venting) to mount this range hood:
Determine venting method as shown on Page 7 and proceed if you would like to vent vertically.
1.
Using references in
2.
Height & Clearance
on Page 5-6,
Measurements and Diagrams
on Page 17-21,
Figure 3 and Figure 4 on next page, determine and clearly mark a centerline on the bottom of the cabi-
net.
Draw electrical wires through cabinet access opening on top of the range hood, center the hood beneath
3.
the cabinet and flush with the front of the cabinet.
From inside of the hood, place hood mounting screws into the exact center of each knockout hole and
4.
secure to cabinet bottom. Finish tightening all screws until secure. Be careful when using electrical
screwdriver, damage to the range hood may occur. Skip Part B below and proceed to Step 2.
CAUTION: Make certain the range hood is secure before releasing!
Determine venting method as shown on Page 7 and proceed if you would like to vent horizontally.
1.
Using references in
2.
Height & Clearance
on Page 5-6,
Measurements and Diagrams
on Page 17-21,
Figure 5 and Figure 6 on next page, determine and clearly mark a centerline on the wall.
Punchure the knockout wire access hole and rear duct access hole on the back of the hood, draw electri-
3.
cal wires through the wire access hole and attach rectangular vent adapter.
Draw electrical wires through the access opening on the wall behind the range hood (Figure 6), center
4.
the hood beneath the cabinet and flush with the front of the cabinet.
From inside of the hood, place hood mounting screws into the exact center of each knockout hole and
5.
secure to the wall. Finish tightening all screws until secure. Be careful when using electrical screw-
driver, damage to the range hood may occur.
CAUTION: Make certain the range hood is secure before releasing!
For safety purpose, pre-drilled mounting holes are provided through the back of the hood. For a more secure
2.
installation, use as many mounting holes as needed to secure from the inside of hood.
Use 6” round steel pipe (follow building codes in your area) to connect the exhaust on the hood to the duct-
1.
work above. Use silver tape or duct tape to make all joints secure and air tight. Refer to Figure 6.
SAFETY WARNING: Risk of electrical shock. this range hood must be properly grounded. Make sure this
is done by qualified electrician in accordance with all applicable national and local electrical codes. Before
connecting wires, switch power off at service panel and lock service panel to prevent power from being
switched on accidentally.
Connect the range hood to a designated standard outlet or cut off the plug and connect three wires (black,
1.
white and green) to house wires and cap with wire connectors. Connect according to colors (i.e. black to
black, white to white, and green to green).
Store excess wires in the wiring box.
2.
Turn Power ON using control panel (refer to
3.
Range Hood Operations
on Page 13-14). Check all lights and
fan operations.
Make sure to leave this Installation Guide for the homeowner.
4.
Page 10
Installation
Summary of Contents for UC200 Series
Page 2: ......
