b
18
process is to take place, because this affects the useful load capacity of
the sling. The sling must lie completely on the load suspension device
(e.g. crane hook) and on the load.
#
Attention: Too strong a lateral enclosure (pinching) decreases
Magnum-X round slings’ load capacity.
3.4 Arranging the load
Place the sling on the load in such a way that it cannot slide on the load
or even off the load during the lifting process. Make sure the lifting strap
does not twist or intersect with the load. Use adequate edge protection
for coarse and/or sharp-edged loads. Make sure that the part of the load
to be fastened to the sling can take the force introduced during lifting.
4 Inspection, maintenance, repair and end of use
Magnum-X round slings must be checked for defects before each use. If you
detect defects, the Magnum-X round slings must be set aside. An autho-
rized person must perform the check according to the employer’s specified
inspection interval, but at least once per year. Depending on the usage and
operational conditions, interim inspections may also be necessary. The
inspections must be documented according to BGR 500. Additionally, all
metallic fittings must undergo crack inspection at least once every three
years. The inspection must be done according to EN 10228 Part 1 (Magnetic
powder testing - “fluxes”) or Part 2 (Penetration Test).
Magnum-X smart
1
round slings have a second, interior tube sleeve in
a signal colour. If the external tube sleeve is damaged, it can easily be
changed by the manufacturer or another authorized person. The internal
tube sleeve’s signal colour makes it easier to notice the damage.
Magnum-X round slings can be repaired, for example, if:
-
the label is missing and the manufacturer is unknown,
-
only the tube sleeve
2
is damaged.
1 The Magnum-X smart is made with a side seam.
2 The Magnum-X smart is equipped with two tube sleeves, while other round slings in the Magnum-X product
line have one.
