SPAREHAND
®
Paddlesports
2 kayak storage system
Model:
KC-103 “Catalina”
v4
Caution – Failure to follow these guidelines can result in property
damage or personal injury.
Parts are not labeled. Before assembly, please identify each part according to the descriptions and
diagrams below.
Do not use if the product or any parts is defective.
Do not tilt or lift the storage rack.
Do not drop kayak or any object on the rack. Place objects carefully and slowly.
Do not step, stand, or climb on the storage unit.
Do not use if loads are not balanced and / or cannot be used on level and secure ground. Always
make sure the rack will not tip over. Secure the rack to the wall or floor if necessary.
Kayak must be placed sideways (horizontally) on cradles. Faces outward and with the upper side
lean against vertical posts. Do not place kayak flat on the cradles.
Always make sure heavier loads are at the bottom and never place your kayak on upper rack
position with the bottom rack empty. Top-heavy loads are dangerous.
Use only if you determine the rack can be used safely.
The manufacture and its agents are not responsible for any damages or injuries caused by the use
or misuse of the product.
This rack is intended for indoor use. This rack may also be used outdoors under certain weather
and climate conditions with proper care and protection only.
Please follow the instructions and observe weight and size limits. Upper level: 90 Lbs and 12 feet
length maximum load. 120 Lbs and 18 feet product length maximum load. Load and size limits
are per pair of cradles.
When moving the storage rack, remove all objects from the rack.
Warranty: 1 year Limited Manufacture’s Warranty.
For technical support or questions regarding this product, please contact
626-338-8998. PST 9:00 AM to 3:00 PM.
--
-
Parts List
-
-----
KC-103 “Catalina” Kayak Rack
-----------------
The following parts are required for KC-103 “Catalina” Kayak Rack
A.
Base Beam (2 PCS)
B.
Cross Beam (2 PCS)
C.
Vertical Post (2 PCS)
D.
Top Cradle (2PCS)
