The devices must be installed and used in strict accordance with the manufacturer's
instructions as described in the user documentation that comes with the product.
This radio transmitter RYK-WUBT239ACNBT has been approved by Federal
Communications Commission to operate with the antenna types listed below, with
the maximum permissible gain indicated. Antenna types not included in this list that
have a gain greater than the maximum gain indicated for any type listed are strictly
prohibited for use with this device.
Unique antenna connector (RP-SMA) must be used on the Part 15 authorized
transmitters used in the host product.
Antenna
Type
Brand Antenna Model
Maximum Gain (dBi)
2.4 GHz
5GHz
Dipole SparkLAN
AD-301N
4.4 dBi
5.8 dBi
Dipole SparkLAN AD-103AG
2.02 dBi
2.03 dBi
Dipole SparkLAN
AD-305N
5 dBi
5.53 dBi
Dipole SparkLAN
AD-303N
3.14 dBi
3.45 dBi
Dipole SparkLAN
AD-302N
3.14 dBi
2.87 dBi
Dipole SparkLAN
AD-315N
3 dBi
5 dBi
Length of RF cable:150mm
Connector type of RF cable: I-PEX/MHF1 to RP-SMA(F)
If the FCC identification number is not visible when the module is installed inside
another device, then the outside of the device into which the module is installed
must also display a label referring to the enclosed module. This exterior label can use
wording such as the following: “Contains Transmitter Module FCC ID: RYK-
WUBT239ACNBT” Or “Contains FCC ID: RYK-WUBT239ACNBT”
The modular transmitter is only FCC authorized for the specific rule parts (i.e., FCC
transmitter rules) listed on the grant, and the host product manufacturer is
responsible for compliance to any other FCC rules that apply to the host not covered
by the modular transmitter grant of certification. The final host product still requires
Part 15 Subpart B compliance testing with the modular transmitter installed.
