5
Original instructions
EN
g)
If devices are provided for the connec-
tion of dust extraction and collection fa-
cilities, ensure these are connected and
properly used. Use of dust collection can
reduce dust-related hazards.
4) Power tool use and care
a)
Do not force the power tool. Use the cor-
rect power tool for your application. The
correct power tool will do the job better and
safer at the rate for which it was designed.
b)
Do not use the power tool if the switch
does not turn it on and off. Any power tool
that cannot be controlled with the switch is
dangerous and must be repaired.
c)
Disconnect the plug from the power
source and/or the battery pack from the
power tool before making any adjust
-
ments, changing accessories, or stor
-
ing power tools. Such preventive safety
measures reduce the risk of starting the
power tool accidentally.
d)
Store idle power tools out of the reach
of children and do not allow persons
unfamiliar with the power tool or these
instructions to operate the power tool.
Power tools are dangerous in the hands of
untrained users.
e)
Maintain power tools. Check for mis
-
alignment or binding of moving parts,
breakage of parts and any other condi
-
tion that may affect the power tool’s op
-
eration. If damaged, have the power tool
repaired before use.
Many accidents are
caused by poorly maintained power tools.
f)
Keep cutting tools sharp and clean.
Properly maintained cutting tools with
sharp cutting edges are less likely to bind
and are easier to control.
g)
Use the power tool, accessories and
tool bits etc. in accordance with these
instructions, taking into account the
working conditions and the work to be
performed.
Use of the power tool for op-
erations different from those intended could
result in a hazardous situation.
5) Service
a)
Have your power tool serviced by a
qualified repair person using only iden
-
tical replacement parts.
This will ensure
that the safety of the power tool is main-
tained.
IV - Rotary hammer
safety warnings
Wear ear protectors with rotary ham
-
mers.
Exposure to noise can cause hearing
loss.
▪
Use the auxiliary handle supplied with the
machine.
Loss of control can cause personal
injury.
During operation provide eye protec-
tion to prevent eyes from exposure to fly
-
ing particles.
Wear goggles.
Take protective measures against inha
-
lation of dust.
Some materials can contain
toxic ingredients. Wear a dust mask and work
with dust/chip extraction when connectable.
▪
Hold the power tool by insulated gripping
surfaces only, when performing an op
-
eration where the cutting accessory may
contact hidden wiring or its own cord. Cut-
ting accessory contacting a “live” wire may
make exposed metal parts of the power tool
“live” and could give the operator an electric
shock.
▪ Do not process materials containing asbes
-
tos. Asbestos is considered carcinogenic.
WARNING:
Before connecting a tool
to a power source ensure that the voltage
supply is the same as that specified on the
nameplate of the tool.
▪ A power source with a voltage greater than
that specified for the tool can result in serious
injury to the user, as well as damage to the
tool.
▪ If in doubt, do not plug in the tool.
▪ Using a power source with a voltage less than
the nameplate rating is harmful to the motor.
▪ Fully unwind cable drum extensions to avoid
potential overheating.
▪ When an extension cable is required, you
must ensure that it has the right ampere rating
for your power tool and it is in safe electrical
condition.
Summary of Contents for BP 330E
Page 2: ...B 2 3 4b 4a 7 6 8 10 1 5 9 А 8 2 3 4 5 1 9 10 6 7 ...
Page 110: ......
