7
Original instructions
EN
AUXILIARY HANDLE
Tighten the auxiliary handle (8) on journal (4) of the drill. The
depth gauge (7) can be used for fixing the depth of the drilled
bores.
REMOVING THE CHUCK
For keyed chuck drills:
Open the jaws of chuck (2) completely, and by means a
screwdriver unwind the left-threaded securing screw. Fix
the drill spindle with an open end spanner.
Put the special key for chuck tightening in one of the
three bores and rotate the chuck anti-clockwise, using
the chuck key as a lever, to unscrew chuck (2) from the
drill spindle.
For keyless-chuck drills:
Grip rear collar of keyless chuck (2) and rotate front collar
until chuck is opened. By means a screwdriver unwind
the left-treaded securing screw. Insert and fasten Allen
key or screwdriver bit into the chuck.
Clamp the place for fixing the spindle (3) by means of a
spanner and rotate the chuck anti-clockwise by the free
end of the key (bit).
RECOMMENDATIONS FOR OPERATION
Apply moderate pressure during drilling in concrete (ap
-
proximately 80–100 N). Higher pressure will not increase
drilling efficiency, but it will lead to decreasing the op
-
eration life of the machine. Drill at speed lower than the
maximum speed and select the speed depending on the
processed material.
Use carbide tipped straight shank drill bits. Take the drill
out of the opening from time to time to remove dust.
Watch out the stage of blunting of the bit and replace it if
considerable decrease of efficiency is observed.
Before drilling large-diameter holes in metal, wood or
plastics, drill a small pilot hole.
The optimum capacity when drilling in concrete is up to 8
mm, and the possible capacity is up to 13 mm.
ACCESSORIES TO BE USED WITH
THIS POWER TOOL
▪ Drill bits for metal Ø1.5 to Ø13 mm.
▪ Drill bits for wood Ø1,5 to Ø20 mm.
▪ Drill bits for concrete Ø3 to Ø13 mm.
▪ 6.35 mm (1/4”) hexagon shank screwdriver bits.
WARNING:
These accessories or attach-
ments are recommended for use with your SPARKY
tool specified in this manual. The use of any other ac
-
cessories or attachments might present a risk of in-
jury. Only use accessory or attachment for its stated
purpose. If you need any assistance for more details
regarding these accessories, ask your local SPARKY
service centre.
Maintenance
WARNING:
Always ensure that the tool is
switched off and unplugged before attempting to perform
inspection or maintenance.
BRUSH REPLACEMENT
When the carbon brushes are worn out, both brushes
must be replaced simultaneously with genuine brushes at
SPARKY service centre for warranty and post-warranty
service.
GENERAL INSPECTION
Regularly inspect all fasteners and ensure they are
properly tightened. Should any of the screws be loose,
retighten it immediately to avoid hazards.
If the replacement of the supply cord is necessary, this
has to be done by the manufacturer or his agent in order
to avoid a safety hazard.
CLEANING
For safe operation always keep the machine and its ventila
-
tion slots (6) clean.
With the motor running, blow dirt and dust out of all air vents
with dry air at least once a week. Wear safety glasses while
performing this.
Exterior plastic parts may be cleaned with a damp cloth and
mild detergent.
WARNING:
Although exterior plastic parts are
highly solvent resistant, never use solvents!
IMPORTANT!
To assure product safety and reliability, re-
pairs, maintenance and adjustment (including brush inspec
-
tion and replacement) should be performed by certified ser
-
vice centres or other qualified service organisations, always
using genuine replacement parts.
pages-BUR 131E-2012.indd 7
16.12.2013 г. 14:53:57 ч.
